Cut to Length 4130 Tubing
For production work, cut to length supply turns tube into a kit of parts. Instead of storing long lengths and sawing each job, you receive labelled pieces in the quantities the build needs.
How Cut-to-Length Supply Works
The process:
1. Buyer provides a complete cut list: all required OD/wall sizes, lengths, and quantities
2. Supplier verifies the cut list against available stock and provides pricing including cutting cost
3. Buyer places the order with approved cut list
4. Tube is cut from stock, deburred if specified, and packaged for delivery with MTC
The MTC covers all cut pieces from the same heat lot. Cut pieces retain full heat lot traceability.
Build a Complete Cut List
For maximum value from cut-to-length service, provide a complete cut list at the enquiry stage rather than ordering in multiple small batches. A complete list enables better pricing, single delivery, and a unified MTC package for the project.
| Cut List Element | What to Include |
|---|---|
| OD & Wall | For every distinct tube size |
| Cut length | Exact length in mm or decimal inches |
| Quantity | Number of pieces per length |
| Length tolerance | e.g., ±2mm or ±1/8" |
| End preparation | Square / deburred / miter (specify angle) |
| MTC | Required for all sizes — state at enquiry |
Tube Kits and Repeat Parts
A roll cage, a chassis or a batch of machines each has a fixed bill of tube: so many pieces of each size at each length. Supplying that bill as a kit means the material for one build arrives together, and the same kit can be reordered by reference.
For repeat parts, agree the part length, tolerance and end condition once. Later orders then need only the quantity. Bundles or boxes can be labelled by part number or by build so pieces go straight to the right work station. Tell us how you want the pieces grouped and marked. The general service is explained under cut to length services, and orders combining several diameters are covered on mixed size orders.
Frequently Asked Questions
What is the minimum cut length for 4130 tubing?
Minimum cut lengths depend on the OD, the cutting method, and the supplier's equipment. Very short cuts (below approximately 2 OD lengths) may not be feasible with standard equipment. State your required minimum length at the enquiry stage.
Can you supply a complete tube kit for a roll cage?
Yes. Send the list of sizes, lengths and quantities and it can be supplied as a set of cut pieces.
Can cut pieces be labelled by part number?
Yes. Say how you want pieces identified and grouped.
Can a tube kit be reordered?
Yes. Keep the list reference and quote it with the quantity of kits required.
Submit Your Cut List
Provide your complete tube cut list for a cut-to-length 4130 supply quotation.
- Complete cut list (OD, wall, lengths, quantities)
- Length tolerance
- End preparation
- Standard
- MTC
- Delivery